If you post your code, it makes things simpler. Now the same question needed to be re-asked by SteveN. So it's very well possible to control the iPod with an AVR, all it takes is some tweeking.īig_Valven, you could have saved yourself and us some time if you would have answered the question about the clock when I asked for it in my first post in this thread. An Arduino core for the ATmega328, ATmega168, ATmega88, ATmega48 and ATmega8, all running a custom version of Optiboot for increased functionality. Im Unterverzeichnis Sources / Firmware / default findet Ihr die uDMX.hex. ![]() This is very unlike standard serial protocol, so you'll have to do some more: after the Printhex, wait a while, and then disable the transmitter (Reset Ucsrb.Txe) and make the TX-line low with Reset Portd.1. Die bekommt ihr hier.Der Link zur Firmware laedt ein Archiv herunter. I did some reading in the links Lee gave, and it says that the Tx-line goes low after the command-sequence has been sent. It does NOT set fuses.Īfter you pressed F4 to program the chip, select the tab "fuses", and set there the correct clock-configuration. ![]() the $baud-command and the delay-commands, like waitms xx. ![]() The $crystal command is a compiler directive, and is used for f.i.
0 Comments
Leave a Reply. |